You can take a profiling picture of the light source with no film negative in front of it, and then use the “from image area” feature in the white balance module to obtain a reference white-balance setting. “expose-to-the-right”, so that the histogram in your camera touches the right hand side without clipping the image.Įnsure the white balance is correctly set up to compensate for the light source used to illuminate the negative. When taking the photograph, adjust the exposure to fully utilise the entire dynamic range of your camera sensor – i.e. If the image of the negative was obtained using a digital camera, then in order to obtain accurate colors in the final image, you will need to take the following points into consideration: a light table or computer monitor) or off-camera flash. You can obtain an image of a negative using a film scanner, or by photographing it against a white light (e.g.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |